01/024-54 8825/8830 PrinterREP 9.5Repairs and AdjustmentsREP 9.5 Developer ModuleParts List on PL 9.8WARNINGSwitch off the Main Power Switch. Disconnect the Power Cord.NOTE: The art used for this procedure was developed for previous products and may notmatch the 8825/8830 configuration exactly.RemovalCAUTIONBefore removing the Developer Module, ensure that there is a clean area on which to place theassembly.1. Loosen the screws and open the Rear Cover.2. Raise and latch the Top Cover.3. Raise and hold the Developer Module Cover while lifting and removing the DeveloperModule Side Cover.4. Lower the Top Cover.NOTE: In the following step, tape the Toner Cartridge dispense holes in order to prevent tonerfrom pouring out when the Toner Cartridge is tipped up for removal.5. (Figure 1): Remove the Toner Cartridge.Figure 1 Removing the Toner CartridgeCAUTIONEnsure that the clamp will not cause interference when the Developer Module is removed.3Pull the plungerwhile performingStep 41Slide the coveropen2Clean the toner from theholes in the dispense areaand place a piece of tapeover the holes4Remove the TonerCartridge
