01/022-198825/8830 Printer Generic Switch RAPStatus Indicator RAPsGeneric Switch RAPInitial ActionsNOTE: This procedure can be used to check any switch. Due to the generic format of this RAPthere will be no specific ADJ, PL or Diagnostic codes identified.Procedure( Figure 1): Enter DIAGNOSTICS (General Procedures). Enter code [xxxx to test the switch(Refer to appropriate BSD for the specific code). Actuate the switch. The switch togglesfrom H to L or from L to H.Y NThe message display indicates LOW all the time.Y NActuate the switch. The voltage at J1-1 (use the actual connector/pin numberfrom the appropriate BSD) goes to less than 0.4 VDC.Y NCheck the wiring between the switch and the Main PWB (A2).If the wiring is OK, replace the switch.Replace the Main PWB (A2) (PL X.X)Replace the Switch (PL X.X)The switch and its circuit appear to be operating normally. check the adjustment or alignmentof the switch.Figure 1 Switch (Generic)
