01/024-78 8825/8830 PrinterREP 9.17Repairs and AdjustmentsREP 9.17 Photoreceptor SealParts List on PL 9.5BWARNINGSwitch off the Main Power Switch. Disconnect the Power Cord.Removal1. Remove the Drum Assembly (REP 9.2).2. (Figure 1): Remove the Right-hand Seal, the Left-hand Seal (not shown), and the Photo-receptor Seal.3. Thoroughly clean the Photoreceptor Seal channel using a vacuum cleaner.Replacement1. Replace the Photoreceptor Seal.a. Carefully fold the Photoreceptor Seal along the perforations.b. Slide the Photoreceptor Seal into the channel, smaller side up, so that the edge ofthe Photoreceptor Seal forms a seal with the inside lip of the channel.c. Using a soft, straight tool (a piece of shimstock works well), carefully push the sealinto the channel, across the entire width of the Xerographic Module.2. Reinstall the Right-hand Seal.a. Insert the red stripe end of the Right-hand Seal underneath the fold of the Photore-ceptor Seal.b. Install the seal fuzzy side up.c. Ensure that the seal is flush against the Xerographic Module Frame.3. Reinstall the Left-hand Seal in the same manner.Figure 1 Removing and Replacing the Photoreceptor SealCleaner BladePhotoreceptorSeal ChannelPhotoreceptorSealRight-handSealXerographic ModuleFrameBlade Retainer (3)
