01/024-818825/8830 Printer REP 9.19, REP 9.20Repairs and AdjustmentsREP 9.19 Roller KitParts List on PL 9.3NOTE: These are the instructions to install Roller Kit 600K58740. The kit contains the followingitems:• Rollers (2)• Pins (2)WARNINGSwitch off the Main Power Switch. Disconnect the Power Cord.Removal1. Raise and secure the Top Cover.2. Open the Image Module.3. (Figure 1): Using pliers, pull out the pin and remove the roller.Replacement1. Replace the roller and pin with parts from the kit.2. Repeat the procedure at the rear of the Image Module.Figure 1 Removing the Front RollerREP 9.20 Image ModuleParts List on PL 9.3NOTE: These are the instructions to install the Image Module Assembly Kit 600K58760. Thekit contains the following:• Image Module AssemblyWARNINGSwitch off the Main Power Switch. Disconnect the Power Cord.Removal1. Remove the Developer Module (REP 9.5).2. Remove the Developer Baffle (PL 9.8).3. Remove the following:a. Rear Door (PL 14.1)b. Front Door (PL 14.2)c. Right Side, Left Lower Cover (PL 14.2)d. Right Side, Right Lower Cover (PL 14.2)e. Right Side, Left Cover (three screws, two top, one bottom) (PL 14.2)f. Right Side, Right Cover (three screws, one top, two bottom) (PL 14.2)4. Remove the High Voltage Power Supply (REP 3.2).NOTE: In the following steps, cut cable ties as necessary in order to remove the harness.PinRoller
