September 2001 88XX Series Folder Operator Manual 16Switching on the FolderAt power on, the Firmware release will be displayed for two seconds:− as a code in the Numeric Control Panel [RX.XX ]− as a message in the Alphanumeric Control Panel “REV. X.XX“When 2 - 3 seconds has expired, the control panels will show either“idle”, an alarm status or (if the system has already submitted a job), theprogram selected.− as a code in the Numeric Control Panel [ le], [A-XX] or [P-XX].− as a message in the Alphanumeric Control Panel “IDLE”,“190+20” or “DOOR OPEN”During the folding process, error messages will be displayed:− as a code in the Numeric Control Panel [E-XX]− as a message in the Alphanumeric Control PanelCode Message Code Messagea-01 DOOR OPEN a-07 ENCODER OR M2 MOTOR FAULTa-02BRIDGE SENSORSCOVERED a-08 STEP MOTORS FAULTa-03UPPER POCKETSENSOR COVERED a-09 NOT IMPLEMENTEDa-04LOWER POCKETSENSOR COVERED a-10 NOT IMPLEMENTEDa-05CROSS POCKETSSENSOR COVERED a-11 FIRST BIN FULLa-06 24V MISSING a-12 SECOND BIN FULLOther errorsCode DescriptionSNot settable value. Folder could generate unexpectedfolding styles due to particular value situation.Is not possible to adjust the styleCode Message Code Messagep-00 NO FOLD P-10 CUSTOMp-01 185 p-11 7,5”p-02 185+25 p-12 7,5”+1”p-03 190 P-13 8,5”p-04 190+20 P-14 9”p-05 198 p-15 WALLET 11”p-06 210 p-16 WALLET 12”p-07 AFNOR p-17 7,5” LANDSCAPEp-08 ERICSSON p-18 8,5” LANDSCAPEp-09 FRENCH p-19 9” LANDSCAPECode Messagee-01 ENTRY ALARM 1e-02 ENTRY ALARM 2e-03 BRIDGE ALARMe-04 ROTATION ALARMe.-05 POCKETS ALARMe-06 FOLDING ALARM 1e-07 FOLDING ALARM 2e-08 FOLDING ALARM 3e-09 FAN FOLDER EXIT ALARMe-10 TRANSPORT ALARMe-11 CROSS ENTRY ALARMe-12 CROSS EXIT ALARMCROSS EXIT ALARM W/PUNCHINGe-13 NOT FOLDABLEE-14 NOT AVAILABLE SELECTIONE-15 LAPS WITHOUT ADJUSTMENTE-16E-17 PROGRAM NOT SELECTABLENote : l SENSOR COVERED ¡ SENSOR UNCOVERED