Xerox 8830 Operator's Manual

Also see for Synergix 8830: User guide Setup guide User guide Release note System introduction

Xerox 8830 Operator's Manual Manual pdf 32 page image

September 2001 88XX Series Folder Operator Manual 31Scanner Job TemplatesThe “Job Template” option is used to simplify the finisher use.All of the finisher settings can be stored in nine different JobTemplates. (refer to the “XES Synergix 8825/8830/8850/8855 DigitalSolution User Guide” for details).By recalling a template number, all of the selections that are stored(Folding method, Cross, Punch, Title Block Location…) areautomatically set.A good way to create the templates is to refer to the standard TitleBlock Location numbering as shown in the picture below.UpperRigthLowerRigthUpperLeftLowerLeft4 1231. Set all of the options and Title Block Location to Upper Right.2. Save the Job Template as “4”3. Change only the Title Block Location to Upper Left and saveanother Job Template as “1”.4. Create the templates “2” and “3” in the same way.With these four templates it is easy to manage different sizes that haveto be folded with the same folding method.Depending on the size orientation, the only thing to do is to recall thetemplate with the proper Title Block Location. All of the sizes fed indifferent ways will result folded with the same Face Orientation.Job template4Job template3Job template1Job template2Using the other templates, it is possible to save another finisher settingwith the four title block combinations.The procedure works only with standard sizes.For non standard sizes the only possible locations are:Location 4 Upper Right - Face UpLocation 2 Lower Left - Face Down