Xerox 8830 Operator's Manual

Also see for Synergix 8830: User guide Setup guide User guide Release note System introduction

Xerox 8830 Operator's Manual Manual pdf 24 page image

September 2001 88XX Series Folder Operator Manual 23Manual Feed SubmenuUse this submenu to set the size and the title block location of the printthat has to be manually fed.1. Go to the “Manual Feed” submenu.in the Numeric Control Panel in the Alphanumeric Control Panelu OPERATORU6 MANUAL FEED2. Enter the last level of the menu to set:− “TITLE BLOCK LOCATION” [ u6.01 ]Set the title block location. Press ”Enter” to access the followingoptions:− LOCATION 1 [ 01 ]− LOCATION 2 [ 02 ]− LOCATION 3 [ 03 ]− LOCATION 4 [ 04 ]− “STANDARD” [ U6.02 ]Use this selection for standard sizes.− “ROLL” [ U6.03 ]Use this menu to set the roll width if the size is not standard.− “LENGTH” [ U6.04 ]If the size is not standard, it is possibleto set the length in this submenu.− “AUTOLENGTH” [ U6.05 ]Automatic length detection, futureoption.− Select FEED IN [ u6.06 ] to activatethe entry flap and to set the folder readyto be Manual Feed.− Select EXIT [ u6.00 ] to rise one level.For a complete description of the“Manual Feed” procedure, refer to thenext pages: “Manual Feed Procedure”Manualfeed u 6Autolength u 6.05Feed in u 6.06Roll u 6.03Length u 6.04Title blocklocation u 6.01u 6.02StandardsizesExit u 6.00