Xerox 8830 Operator's Manual

Also see for Synergix 8830: User guide Setup guide User guide Release note System introduction

Xerox 8830 Operator's Manual Manual pdf 41 page image

September 2001 88XX Series Folder Operator Manual 40Introduction to Jam Clearance ProceduresA series of corrective procedures are to be used by the operator to clearjams.Note: If a jam occurs during a multi-print procedure, the bridge flapgoes up and the folder goes into the Pause Mode. This operation iscovered fully in the Pause Mode Procedure.The following pages will give you the detailed steps to take when youare clearing a jam. The folder will inform the operator where the jam islocated by using an alarm tone and the message display:• A single tone if jam occurs in the Bridge• A double tone if the jam occurs in the Fan Section• A triple tone if the jam occurs in the Cross SectionTo avoid larger jams, perform the Automated Eject Procedure. Keep theReset key pressed for more than two seconds. Then when the reset key ispressed, the rollers start. If the reset key is pressed for less than twoseconds, after a five-second delay, the folder exits the Manual EjectProcedure.If the Manual Eject Procedure does not succeed in removing the paperjam, follow the procedures on the following pages.Safety Bridge LeverTo tilt up the bridge:1. Disengage the Bridge Hook (8855 only) .2. Using the handle, tilt up the bridge, ensuring that the lever lowersdown into the slot under control.3. Check that the safety lever is latched in the correct position.BE CAREFULIf the safety lever is not latched in the correct position, the bridge coulddrop down and cause serious damage to the machine or to the operator.To let down the bridge:1. Release the bridge safety lever.2. Lower the bridge to the horizontalposition.3. Make sure that the bridge engagesthe printer brackets.111378