Xerox 8830 Operator's Manual

Also see for Synergix 8830: User guide Setup guide User guide Release note System introduction

Xerox 8830 Operator's Manual Manual pdf 50 page image

September 2001 88XX Series Folder Operator Manual 49FoldingPrint sizes− ANSI, ARCH sizes : A (pass through), B, C, D, E− ISO, Afnor, Ericcson sizes : A4 (pass through), A3, A2, A1, A0Longitudinal folding panel ANSI, ARCH:− 7 ½ “, 8 ½ “, 9”, 11”, 12” (6½ inches to 12 inches)− Margin between 0 to 2 inches (step 5 mm)Longitudinal folding panel (E0):− 185mm, 190mm, 198mm, 210mm, 297mm, (165mm to 305mm)− Margin between 0 to 30 mm (step 5 mm)Cross folding panel - cross (E0/US):− 210mm/8½”, 297mm/11”, 305/12”mm (between 165 to 305mm)ConfigurationWhere possible, the Universal Folder is available with the standardconfiguration, and has the ability to add the following additionaloptions:Second Output Bin:• The Second Output Bin increases the capacity of the folder up to200A0/E.• The Second Output Bin also avoids system stops: if the first bin isfull, the system still goes on stacking the prints in the second bin.• The second bin also increases the system speed when two copies of ajob are needed: the Sorter Mode allows printing two copies of adocument and sorts them one per bin. In this way the printeroptimizes the rolls usage because it does not print all of the job twicewith changing the roll for every document. Instead, it printssequentially two copies of each document without loosing time dueto changing the rolls.Rotation:• The Rotation enables the Folder to rotate the A2/C size. This allowsthe folder to be combined with a printer that has three media rolls. Itcan then make five standard sizes without the need to replace themedia roll.Punching:• The Punching Device is a tool to make 3 or 4 holes automatically inthe binding margin of the folded print. The Punching option requiresthe installation of the Rotation Bridge.Alphanumeric Control Panel:• The Alphanumeric Control Panel is available for the user whowishes to have full feature selection, remotely from the system clienttools. This Alphanumeric Control Panel is included when the folderis installed with the 8855 printer.Listed below, are the five possible configurations to increase thecapability of the folder. Every optional will be indicated with a letter:Rotation = R2 nd basket = B2Punching = H3/H4 (under development)Control Panel option = CConfiguration 2nd Basket Punching RotationSTANDARD NO NO NOSTANDARD - R NO NO YESSTANDARD - B2 YES NO NOSTANDARD - R - B2 YES NO YESSTANDARD - R - Hn - B2 NO YES YES

/ 51

Related manuals for Xerox Synergix 8830