Transmission701Note❒ To send to a G3 fax via a gateway connected to a public telephone line, youmust specify the receiver's machine telephone number. For example, if the re-ceiver's fax number is “0312345678”, specify “5678”. To send from an IP-Faxto G3 fax without using gatekeeper or SIP server, you must register the gate-way also.❒ When you specify a destination with IP-Fax, depending on the receiver's net-work configuration, you may need to specify the IPv4 address and port num-ber of the receiving machine. For example, if the receiver's IPv4 address is“192.168.1.10” and the port number is “2100”, specify “192.168.1.10:2100”.Ask the network administrator for details.❒ When you specify a host name, depending on the receiver's network config-uration, you may need to specify the host name and port number of the re-ceiving machine. For example, if the receiver's host name is “IPFAX1”and theport number is “2100”, specify “IPFAX1:2100”. Ask the network administra-tor for details.❒ An alias telephone number is a number that is registered in the gatekeeper,and is available only in the network to which the gatekeeper is connected.❒ Pay attention to the number of telephone number digits set in the gate-way/IPv4 address conversion table to avoid transmission error.Sending to an E-mail AddressThis section explains how to specify an e-mail address as a destination.When using Internet Fax transmission, specify the e-mail address in place of thefax number.Important❒ In the destination list, register senders, specify their e-mail addresses, and setthe User Name as [Sender] in advance.❒ Internet Fax is executed in only Memory Transmission that starts transmis-sion automatically after storing documents in memory. If you switch the typeof transmission to Internet Fax while the machine is in the Immediate Trans-mission mode, the transmission mode is automatically switched to the Mem-ory Transmission mode.
