Xerox CopyCentre C118 System Administration Manual

Also see for Copycentre C118: User guide User manual Module guide Network guide Quick installation card

Contents

Xerox CopyCentre C118 System Administration Manual Manual pdf 103 page image

Using CentreWare Internet Services to Configure Settings on the MachineXerox CopyCentre/WorkCentre 118 System Administration Guide 1034. Set up the following option to be displayed in the frame.• Port NumberNOTE: For more information about the options, refer to Properties in the CentreWareInternet Services chapter of the User Guide.5. Select [Apply New Settings] to reflect the new setting.6. Enter the user ID and password, then select [OK].NOTE: The default user ID is "admin" and the default password is "x-admin".7. When the reboot message appears, select [Reboot].E-mailThis page allows you to configure the E-mail settings for the following options.NOTE: Some settings on this page will only be available after you reboot the machinefrom CentreWare Internet Services, or after the machine is switched off and on.1. At the CentreWare Internet Services home page for the machine, select the[Properties] tab.2. In the [Properties] frame, select the plus symbol [+] to the left of the [ProtocolSettings] folder.3. Select [E-mail].4. Set up the following options to be displayed in the frame.• POP3 Server Address (Specify when the machine sends the E-mail using the POPbefore SMTP feature.)• Max. no. of pages for Split Send• POP User Name (Specify when the machine sends the E-mail using the POP beforeSMTP feature.)• POP User Password (Specify when the machine sends the E-mail using the POPbefore SMTP feature.)• Re-enter Password• SMTP Send Authentication – POP before SMTP• SMTP Server Address or Host Name. If Host Name is used, ensure that the DNSsetting is correct. The DNS setting can be accessed from [Properties] > [ProtocolSettings] > [TCP/IP].NOTE: For more information about the options, refer to Properties in the CentreWareInternet Services chapter of the User Guide.5. Select [Apply New Settings] to reflect the new setting.6. Enter the user ID and password, then select [OK].NOTE: The default user ID is "admin" and the default password is "x-admin".