Xerox CopyCentre/WorkCentre 118 System Administration Guide 595 EtherTalkThis chapter explains how to set up the machine to operate on an EtherTalk network.The following information is provided.Information Checklist – page 59EtherTalk Environments – page 60EtherTalk Installation – page 60Installation Procedure – page 60Network Communication Setup – page 60Workstation Setup – page 62Test Print – page 62Information ChecklistBefore installing EtherTalk on the machine, make sure that the following items areavailable or have been performed.If problems are encountered during the machine installation, refer to the ProblemSolving chapter for assistance.CAUTION: Do not connect the network cable to the machine until instructed todo so.Item ByAn existing operational EtherTalk network with Macintosh workstationsequipped with Ethernet network interface cards is required. Theseprocedures are not designed to install an EtherTalk network.CustomerMacintosh System versions 7.5 or later, 8.x, 9.x, or Mac OS X 10.2 CustomerObtain and record the following information:• IP address• Gateway address• Subnet mask• Host nameRefer to the glossary for additional information about the GatewayAddress and Subnet mask, if needed.CustomerTest the machine to make sure that it is installed fully and functioningcorrectly.CustomerAdobe PS print driver, or PPD (optional). Customer
