Xerox CopyCentre C118 System Administration Manual

Also see for Copycentre C118: User guide User manual Module guide Network guide Quick installation card

Contents

Xerox CopyCentre C118 System Administration Manual Manual pdf 73 page image

TCP/IP (LPD or Port9100) InstallationXerox CopyCentre/WorkCentre 118 System Administration Guide 73Network Communication SetupEnable the following ports using the control panel or CentreWare Internet Services.• Printing through LPD: LPD port• Printing through Port9100: Port9100 portSet the IP address using the control panel.NOTE: CentreWare Internet Services allows more detailed settings. Refer toCentreWare Internet Services chapter on page 91.Workstation SetupThis requires the workstations in the networking environment to be configured tocommunicate with the machine.Test PrintA print job should be submitted to make sure that the machine has been installed andconfigured correctly.Network Communication SetupThis section describes how to set up the network communication parameters of themachine.At the machine, perform these steps.NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IPnetwork.NOTE: CentreWare Internet Services can also be used to configure the machine.Refer to CentreWare Internet Services chapter on page 91.First, enable the [LPD] or [Port9100] port.1. Connect the machine to the network.2. Press the button.3. Select [System Settings].4. Enter the password using the numeric keypad and then select [Confirm].5. Select [Print Settings] and then press the button.6. Press the button on the [Network/Port] screen.7. Select [LPD] or [Port9100] by selecting [T] or [S] and then press the button.8. Select [Port Status] by selecting [T] or [S] and then press the button.9. Select [Enable] by selecting [T] or [S] and then press the button.