Xerox® DocuMate® 4790User’s Guide4-134InstallationBefore You BeginPlease make sure of the following before you begin installation:• The information in this guide may cover software not provided with the scanner you purchased. Pleasedisregard any information about the software not applicable to your scanner.• If your computer has AntiVirus or AntiSpyware software running, you may encounter alerts or messagesduring installation asking you to allow the installation to proceed. Although the messages will differ basedon the software your computer is running, in each case you should allow the installation to proceed if thatoption is available. Alternatively, you can turn off the AntiVirus or AntiSpyware software before installingyour scanner, but if you do, make sure to turn it back on again when installation is finished.• If you already have a scanner connected to your computer, it is recommended that you remove thatscanner’s driver program prior to installing your Xerox scanner. You can remove these programs from theWindows Control Panel. Please refer to the user manual provided with your other scanner hardware forinstructions about removing the driver and software for that unit.• If your computer is running Windows Vista or later, you may see the Windows User Account Control screenasking you to confirm system changes. Click the Yes button to allow the installation to proceed.• The Windows User Account Control (UAC) must be turned off prior to installing the Kofax VRS or Kofax ScanDemo software. The Kofax VRS installer will display a message stating "User Account Control is enabled onthis machine. The VRS installer will not install correctly with this setting enabled. Please disable this settingfrom the User Accounts dialog in the Control Panel." The Kofax Scan Demo installer will display a messagestating "Cannot find IC runtime. Install IC." Turn off the Vista UAC to complete the installation of these twosoftware applications. You can turn UAC back on after the installation has completed.