Scanning and Configuring One TouchXerox® DocuMate® 4790User’s Guide6-816. Put the document(s) in the scanner and start scanning with the button you set to use the Send to Applicationdestination.7. The scanner starts scanning and, when finished, sends the scanned file to the application you selected.Technical note• After configuring this link, you may need to click Refresh in the One Touch Properties window to show thecorrect application icon in the Select destination list.Configure advanced features—select this option to change the default settings for this link. Only advancedusers and application developers should modify these settings.• Launch application for every image—when this option is selected, the application will open one time foreach image scanned. You should deselect this option only if the application you are scanning to will acceptmultiple page files.For example, Microsoft’s Paint application can only accept 1 image at a time, so when scanning multipleimages, Paint would open each time an image is transferred when this option is selected. On the other hand,Microsoft’s WordPad will open a multiple page file, so when scanning multiple images WordPad would needto launch only one time when this option is not selected. If you scan to WordPad and this option is stillselected, then WordPad will open 1 time for each image transferred.• Command line arguments—input the options that are to be used when the application is launched. Thesevalues are application specific and you should only input values that were provided to you by the applicationdeveloper. Command line arguments are not required for you to use this link, the field can be left blank andyou can change the other settings in this section as needed.• Append scan filename(s) to arguments—this option adds the name of every image file to the end of thelist of arguments specified above. This is the default selection as most applications do not require, and maynot work with, a job file containing the image names.• Append job file to arguments—this option adds the name of a job file to the end of the list of argumentsspecified above. This unique file is created at scan time and contains a list of every image in the scan job.Only select this option if you are sure that the application you are scanning to can use the job file to acceptimage transfer.Send to Application One Touch LinkProperties windowSend to Application Scan ConfigurationProperties window
