Printer Console Error Messages10-24Messages About the Printer and Other ItemsMessage Condition/Reason/ActionController ErrorError 116-XXXRestart PrinterAn internal controller error occurred.Restart the printer.Disabled FunctionError 016-758Press Ok ButtonThe function that you are trying to access has been disabled.Enable the function through the printer console menus, or contact yourprinter administrator.See Using the Printer Console Menus and Keypad on page 9-1.Front Cover Open.Close Front CoverThe front cover is open.Close the front cover.Fan Motor ErrorError 042-358Restart PrinterAn error has occurred with the fan.Restart the printer. If the error continues, contact the Fuji Xerox localrepresentative office or an authorised dealer.Fuser Unit ErrorError 010-397Error Code:xxxxxxxxRestart PrinterA fuser error has occurred.Restart the printer.If the error continues, contact the Fuji Xerox local representative office oran authorised dealer.Invalid JobError 016-799Press OK ButtonWhen the system settings of the printer on the print driver does not conformto the printer you are using, this message appears.Press the Stop button to cancel the print driver.Make sure that the system settings of the printer on the print driverconforms to the printer you are using.Jam at Manual FeederRemove Paper fromManual Feeder.Open/Close Front CoverPaper is jammed inside the Manual Feeder.Remove the jammed paper.Open and close the front cover.See Paper Jams on page 10-2.Jam at Tray 1Check Tray 1.Open/Close Front CoverPaper is jammed inside Tray 1.Remove the jammed paper. Open and close the front cover.See Paper Jams on page 10-2.Limit ExceededError 016-759Press OK ButtonThe user has exceeded the limit on the number of pages that can be printedwhen using an authentication function.Contact the administrator.MCU Firmware ErrorError 024-340Error Code:xxxxxxxxRestart PrinterA firmware error has occurred.Restart the printer.If the problem persists, contact the Fuji Xerox local representative office oran authorised dealer.MCU NVRAM ErrorError 041-340Error Code:xxxxxxxxRestart PrinterA NVRAM error has occurred.Restart the printer, and if the problem persists contact the Fuji Xerox localrepresentative office or an authorised dealer.
