Configuring the Network Address4-7Manually Setting the Printer’s IP AddressNote: Verify that your computer has a properly configured IP address for your network. Contact yournetwork administrator for more information.If you are on a network without a DHCP server, or in an environment where the network administratorassigns printer IP addresses, you can use this method to manually set the IP address. Manually setting theIP address overrides DHCP and AutoIP. Alternatively, if you are in a small office with a single PC and usea dialup modem connection, you can manually set the IP address.Using the Printer ConsoleTo manually set the IP address:1. On the printer console, press the System button.2. Select the Admin Menu, and then press the OK button.3. Select the Wired Network menu, and then press the OK button.4. Select the TCP/IP menu, and then press the OK button.5. Select the IPv4 menu, and then press the OK button.6. Select Get IP Address, and then press the OK button.7. Select Panel, and then press the OK button.8. Select IP Address under the IPv4 menu and use the arrows to configure the IP values, and then pressthe OK button.Information Required for Manual IP AddressingInformation CommentsInternet Protocol (IP) address of the printer Format isxxx.xxx.xxx.xxx, wherexxx represents adecimal number from 0–255.Network Mask If you are unsure, leave this blank; the printer choosesan appropriate mask.Default Router/Gateway address Router address is required to communicate with thehost device from anywhere other than the local networksegment.
