Technical informationDocuTech 61xx Operator Guide 7-19Paper stock rotationThis section identifies the limitations on the rotation of paperstock in the DocuTech 6xx Bypass Transport when using a third-party finishing device.BackgroundDue to the physical limitations of the DocuTech 61xx BypassTransport, some paper stocks will be damaged or will jam whilebeing rotated. Currently, when using an external finishing devicethat is not a Signature Booklet Maker, there is no messagedisplayed on the DocuSP controller to warn the Print ServicesOperator that the paper stock to be rotated will not fit in theBypass Transport.The Signature Booklet Maker attached to a DocuTech 61xxprinter is only capable of handling paper stock up to 9 inches(229 mm) in length in a portrait orientation.Weight Substance 16 to 110 (60 to200 g/m2)Weights cannot beintermixedSubstance 16 (60 g/m2)over 9 x 14 inches (229 x356 mm) may yield stackingregistration problems.Weights outside the limitsshown are not recommended.Capacity 500 sheets, substance 20(75 g/m2) or less415 sheets, substance 24(90 g/m2)310 sheets, substance 32(120 g/m2)225 sheets, substance 110(200 g/m2)If using a paper heavier thansubstance 20 (75 g/m2),unload the tray before thecount in the tray reaches 500.Check the stitch quality.Type orconditionXerographic bond paper ingood conditionDrilled paperThese may yield stackingregistration problems:Slightly curled paperPrecut tabs cannot be sentto the top tray.Do not use excessively curledpaper.Stock not defined here isincluded in the “Using variousstocks” section in this guide.Table 7-16. Top tray satisfaction guideStockReliable stacking may beexpectedLess reliable stacking maybe expected Suggested alternatives
