Problem solving6-10 DocuTech 61xx Operator GuideWARNINGThe binder tape adhesive is hot, approximately 425°F(218°C). Allow the binder to cool for 5 minutes with thefinisher doors and top cover open before touching thebinder tape.7. If area 18 is not displayed, proceed to step 10.8. If area 18 is displayed and the entire binder tape length is notaligned with the tape feeder assembly, stop and follow theWARNING. Proceed to step 10.9. If area 18 is displayed and the entire binder tape length isaligned with the tape feeder assembly, proceed to step 10.10. Remove the binder tape.11. Ensure that area 18 is clear of all binder tape adhesive. If it isnot, clean the binder using the procedure, "Cleaning thebinder," in the "Routine maintenance" chapter.12. Close the finisher doors.13. Close the top cover.Clearing a stitcher spool A faultRepeated jams in area 17 may be caused by the followingproblems:• Stitcher wire not feeding properly• A kink in the stitcher wire1. Open the finisher doors.2. Lift the stitcher panel, which is located directly above thestitcher spools.NOTE: If the spool is empty, replace the stitcher spool A usingthe procedure, "Replacing the stitcher spool A," in the "Routinemaintenance" chapter.3. Ensure that there is wire on the spool.4. Pull the green stitcher head release handle forward and upuntil it latches into place, as shown in figure 6-1.
