Problem solvingDocuTech 61xx Operator Guide 6-9Clearing a binder tape faultPerform the following to clear a binder tape fault.1. Open the finisher doors.2. Open the top cover.WARNINGThe binder tape adhesive is hot, approximately 425°F(218°C). Allow the binder to cool for 5 minutes with thefinisher doors and top cover open before touching thebinder tape.3. Follow the instructions on the screen to determine the area(17 or 18) that should be cleared.4. If area 17 is displayed and the binder tape is present, stopand follow the WARNING. Remove the binder tape andpaper. Proceed to step 6.5. If area 17 is displayed and the binder tape is not present,follow the instructions on the area 17 label and remove allpaper.6. Ensure that area 17 is clear of all binder tape adhesive. If thearea is not clear, clean the binder using the procedure,"Cleaning the binder," in this guide.Sheets are spilling outof the top trayThe capacity of the top tray is 500 sheets of substance 20 (75 g/m2) or 2inches (51 mm) in height. When intermixed stock or paper heavier thansubstance 20 (75 g/m2) is being run, the capacity of the top tray isreduced.500 sheets of substance 20 (75 g/m2) is equal to approximately:415 sheets of substance 24 (90 g/m2)310 sheets of substance 32 (120 g/m2)225 sheets of substance 110 (200 g/m2)If using any paper heavier than substance 20 (75 g/m2) or intermixed stockof different weights, unload the top tray before the count in the tray reachesits capacity limit.Refer to the satisfaction guides in the "Technical information" chapter.Table 6-3. Resolving a finisher problem
