Routine maintenanceDocuTech 61xx Operator Guide 5-17NOTE: If any dry ink should get on your skin, wash with mildsoap and cold water.Replacing the dry ink waste containerWhen directed by a screen message, replace the dry ink wastecontainer. If the dry ink waste container is not replaced, theprinter will eventually stop, and it will not operate until the dry inkwaste container is replaced.CAUTIONDo not tip the waste container.CAUTIONDo not use warm or hot water, or general cleaning solvents toremove dry ink from your skin or clothing. The heat or solventwill set the dry ink and make it difficult to remove. If any dry inkshould get on your skin, wash with mild soap and cold water.If any dry ink should get on your clothes, brushing with a drypaper towel or a stiff-bristled brush may remove the ink. If not,launder your clothes with detergent and cold water. Tell acommercial dry cleaner that the spot is dry ink or "toner" so thatthey will not use a solvent that will set the dry ink stain.1. Open the processor doors and locate the dry ink wastecontainer.2. Place a drop cloth on the floor under the dry ink wastecontainer area.3. Remove the full waste container from the system.a. Grasp the tab on the dry ink waste container and pull thecontainer out slowly, as shown in figure 5-14.
