• The power cable is damaged or frayed.• A wall panel circuit breaker, fuse, or other safety device has been tripped.• Liquid is spilled into the printer.• The printer is exposed to water.• Any part of the printer is damaged.Operational SafetyYour printer and supplies were designed and tested to meet strict safety requirements. These includesafety agency examination, approval, and compliance with established environmental standards.Your attention to the following safety guidelines helps to ensure the continued, safe operation of yourprinter.Operational Guidelines• Do not remove any trays when the printer is printing.• Do not open the doors when the printer is printing.• Do not move the printer when it is printing.• Keep hands, hair, neckties, and so on, away from the exit and feed rollers.• Covers, which require tools for removal, protect the hazard areas within the printer. Do not removethe protective covers.• Do not override any electrical or mechanical interlock devices.• Do not attempt to remove paper that is jammed deeply inside the printer. Switch off the printerpromptly and contact your local Xerox representative.Warning• The metallic surfaces in the fuser area are hot. Always use caution when removing paper jams fromthis area and avoid touching any metallic surfaces.• To avoid a tip hazard, do not push or move the device with all the paper trays extended.Ozone ReleaseThis printer produces ozone during normal operation. The amount of ozone produced is dependent oncopy volume. Ozone is heavier than air and is not produced in amounts large enough to harm anyone.Install the printer in a well-ventilated room.For more information in the United States and Canada, go to www.xerox.com/environment . In othermarkets, please contact your local Xerox representative or go to www.xerox.com/environment_europe.Printer Location• Place the printer on a level, solid, non-vibrating surface with adequate strength to hold its weight.To find the weight for your printer configuration, refer to Physical Specifications.• Do not block or cover the slots or openings on the printer. These openings are provided for ventilationand to prevent overheating of the printer.• Place the printer in an area where there is adequate space for operation and servicing.1-3Xerox® VersaaLink® B600/B610 PrinterUser GuideSafety
