InstallationXerox® Wireless Print Solutions AdapterUser Guide16To Start WPS1. Press and hold down the WPS Button for at least 5 seconds.2. Release the button.The unit starts in Wi-Fi protected setup mode, indicated by a slow-flashing green light.3. Within 2 minutes, to pair the device, press the WPS button on the router or access point.Installing the Wireless Print Solutions AdapterEnsure that you place or mount the device securely on a flat horizontal or vertical surface. The devicecomes with hook-and-loop adhesive strips to enable you to mount it securely to a flat surface.Notes:• The Wireless Print Solutions Adapter comes with one 5 VDC Power Supply, and a selection ofinternational AC power adapters.• If you use AC power, do not use outlets that are controlled by a wall switch.• When connected to power, the adapter powers on and automatically runs a self-test, andthe LEDs illuminate to indicate the device status.To install your device, perform the following steps:1. Connect an RJ-45 Ethernet cable between Wireless Print Solutions Adapter unit and the Ethernet porton your printer.2. Select and install one of the AC power adapters on the 5 VDC Power Supply. For details, see theWireless Print Solutions Adapter Installation Guide supplied with the device.3. To power on the device, plug in the device to the power supply provided.4. Check for Status LED activity and monitor according to Status LED on page 15.5. On your personal computer or mobile device, navigate to your list of available networks, then selectthe SSID for your Wireless Print Solutions Adapter. The SSID appears as “wpsa-xxxx” with the last fourcharacters matching the last four characters of your adapter's wireless MAC address. For details, seethe Wireless Print Solutions Adapter Installation Guide, or Cannot find the SSID for the Adapter inavailable wireless connections. on page 49.6. Open a web browser, then to access your Wireless Print Solutions Adapter, type its default IP addressof 192.168.0.1. The Quick Installation page appears.7. To continue installing the Wireless Print Solutions Adapter, log in to Web Manager.– The default login is admin.– The default password is PASS.8. Complete the Quick Setup procedure. For details see Quick Setup on page 44.