Administration PageXerox® Wireless Print Solutions AdapterUser Guide44Quick SetupQuick Setup provides a window to configure all basic settings for the Wireless Print Solutions Adapter. Youcan access Quick Setup on the Administration page and whenever you reset the Wireless Print SolutionsAdapter to factory defaults. For details, see To Configure System Settings on page 41.To Access the Quick Setup Page1. In the Web Manager, click the Administration tab.2. Click Quick Setup.3. On the verification window that appears, click OK.Note: If you want to bypass Quick Setup and proceed to the Status page, at the bottom of the page,click Advanced Setup.To Configure Quick Setup Details1. For Locale, select the desired Language from the menu.2. For Bridge 1 (br0):a. For State, select to enable or disable the state.b. For Bridging Mac Address, type the bridging Mac address details.3. For Network (wlan0):a. For Network Name (SSID), view the existing network/SSID name, if one is configured.b. For State, select to enable or disable the state.c. For DHCP Client, select to turn DHCP Client on or off.d. for IPv6 DHCP Client, select to turn IPv6 DHCP Client on or off.4. For Available Networks:a. For Refresh scan ever 60 seconds, select the check box, then click Scan to scan the availablenetworks every 60 seconds.b. Scroll through the list of available networks, as needed.5. For Printer, any printer that is configured appears.6. For Add Printer:a. For IP Address, type the IP address for the printer.b. For Name, type the name of the printer as it will appear in the user interface.c. For Location, type the location of the printer as it will appear in the user interface.7. To clear any of the options that you have selected at any time, click Clear.8. To submit your selections for Quick Setup, click Submit.Installing New FirmwareYou can install firmware for your Wireless Print Solutions Adapter when updates are released on Xerox.com.