Network Connectivity38 Xerox ® WorkCentre® 3615 Black and White Multifunction PrinterSystem Administrator Guide6. To select Encryption, under Security Settings, select the appropriate security option for your router.7. To remove the dots in the Passphrase field, select them, then press Backspace.8. In the Passphrase field, enter the network passphrase. To remove the dots in the Re-enterPassphrase field, select them, then press Backspace.9. In the Re-enter Passphrase field, re-enter the network passphrase.10. Click Save Changes.11. Disconnect the Ethernet cable from the printer.12. Turn off the printer, then turn it on again.When the printer restarts, it uses the information from CentreWare Internet Services to connectwith the wireless router.Wait about two minutes, then print a Configuration Report to check the connection. If the printer doesnot successfully connect with the wireless network, check your network information and try again.Connecting to a Wireless Network Using the Printer Setup UtilityBefore you begin, ensure that you have the wireless network Service Set Identifier (SSID), encryptiontype, and passphrase. For details, see Collecting Wireless Network Information for Connecting to aWireless Network Manually on page 36.Note: To use the Printer Setup Utility for setting up on a wireless network, connect your printer toyour computer through the Ethernet wired network. You can also use the Printer Setup Utility to setup the printer connected with a USB cable.1. Open the Printer Setup Utility.2. At the Select Configuration screen, select Wi-Fi Configuration, then click Next.3. At Select the current connection to printer screen, select the connection type the printer is currentlyusing.4. Click Next.5. From the Access Point list, select the SSID for the network to which you wish to connect.6. If the desired network does not appear in the list, select Input the SSID directly, then enter thenetwork name in the SSID field.7. Click Next.8. In the Password field, enter the password for the selected network.9. Click Next.10. On the IP Address Settings screen, select the IP Mode to use for the connection:− Dual Stack: Allows the router to assign IPv4 and IPv6 IP addresses, as needed.− IPv4: Directs the router to assign an appropriate IPv4 address only.− IPv6: Directs the router to assign an appropriate IPv6 address only.11. Select the type of method to assigning the IP address:− DHCP allows your DHCP server to assign an IP address to the printer. This option enablesDynamic DNS Registration.− Auto IP allows the printer to assign an IP address to itself, in the absence of a DHCP-capablerouter or access point.
