TroubleshootingXerox ® WorkCentre® 3615 Black and White Multifunction Printer 155User GuidePrinting Takes Too LongProbable Causes SolutionsThe printer is set to a slower printing mode,for example, for printing on glossy orheavyweight paper.It takes more time to print on certain types of special paper. Ensurethat the paper type is set properly in the driver and at the printercontrol panel. For details, see Print Speed on page 193.The printer is in Energy Saver mode. Wait. It takes time for printing to start when the printer is comingout of Energy Saver mode.The way the printer was installed on thenetwork could be an issue.Determine if a print spooler or a computer sharing the printer isbuffering all print jobs and then spooling them to the printer.Spooling can slow print speeds. To test the speed of the printer,print some information pages such as the Office Demo Page. If thepage does not print at the rated speed of the printer, there could bea network or printer installation issue.The job is complex. Wait. No action needed.The print-quality mode in the driver is set toEnhanced.Change the print-quality mode in the print driver to Standard.The printer quality is set to Photo and theprinter is being used for complex, 2-sidedprint jobs.Increase memory size to 4 GB RAM by installing the optional DeviceMemory.Document Prints From Wrong TrayProbable Causes SolutionsApplication and print driver have conflictingtray selections.1. Check the tray selected in the print driver.2. Go to the page setup or printer settings of the application fromwhich you are printing.3. Set the paper source to match the tray selected in the printdriver or set the paper source to Automatically Select.Note: To have the print driver select the tray, set the tray used asthe paper source to Auto Selection Enabled.
