SafetyWorkCentre 6505 Color Laser Multifunction PrinterUser Guide10Electrical SafetyThis section includes:• General Guidelines on page 10• Laser Safety on page 10• Power Cord on page 10General GuidelinesWARNING: Do not push objects, including paper clips or staples, into slots or openings on theprinter. Contact with a voltage point or shorting out a part could result in fire or electrical shock.WARNING: Do not remove the covers or guards that are fastened with screws unless you areinstalling optional equipment and are instructed to do so. Power must be OFF when performingthese installations. Disconnect the power cord when removing covers and guards for installingoptional equipment. Except for user-installable options, there are no parts that you can maintainor service behind these covers.Note: Leave the printer on for optimum performance. It does not pose a safety hazard. If,however, you do not use the printer for an extended period, turn it off and unplug it.The following are hazards to your safety:• The power cord is damaged or frayed.• Liquid is spilled into the printer.• The printer is exposed to water.If any of these conditions occur, do the following:1. Turn off the printer immediately.2. Disconnect the power cord from the electrical outlet.3. Call an authorized service representative.Laser SafetyThis printer complies with laser printer performance standards set by governmental, national, andinternational agencies and is certified as a Class 1 Laser Product. The printer does not emit hazardouslight because the beam is enclosed during all modes of customer operation and maintenance.WARNING: Use of controls, adjustments, or performance of procedures other than theprocedures specified in this manual can result in hazardous radiation exposure.Power Cord• Use the power cord supplied with your printer.
