Initial Setup22 Xerox ® WorkCentre® 6655 Color Multifunction PrinterSystem Administrator GuideInitial Setup at the Control PanelInstallation WizardThe Installation wizard starts the first time you turn on the printer. The wizard prompts you with a seriesof questions to help you configure basic printer settings.Note: You can change these settings at any time.Quick Setup HomeAfter the Installation wizard completes, the Quick Setup Home wizard appears. Use the Quick SetupHome wizard to configure printer settings.Note: You can complete the wizard at any time.• Use the IP Address Settings wizard to assign a static IP address or change the default dynamicaddressing settings.• Use the Contact Numbers wizard to type phone numbers for support or supplies.• Use the Fax Setup wizard to configure basic embedded fax settings.After the Quick Setup Home wizard completes, the printer restarts and a Configuration Reportautomatically prints.1. At the printer control panel, press the Machine Status button, then touch the Tools tab.2. Touch Device Settings>Quick Setup Home.3. To start a wizard, touch IP Address Settings, Contact Numbers, or Fax Setup.4. Follow the onscreen instructions.Note: Not all options listed are supported on all printers. Some options apply only to a specificprinter model, configuration, operating system, or driver type.Setting the Measurement Units1. At the printer control panel, press the Machine Status button, then touch the Tools tab.2. Touch Device Settings>General>Measurements.3. To show dimensions in metric or imperial units, under Units, select an option.4. To specify the decimal mark symbol that the printer uses, under Numeric Separator, select Commaor Period.5. Click Save.
