Regulatory InformationPan-European Analog PSTN andCompatible PBX CertificationsFinland Lithuania SpainFrance Luxembourg SwedenGermany Malta United KingdomThis product has been tested to and is compliant with TBR21 OR ES 103 021-1/2/3 or ES 203 021-1/2/3technical specifications for terminal equipment for use on analog-switched telephone networks in theEuropean Economic Area.If you have problems with your product, contact your local Xerox representative. This product can beconfigured to be compatible with other country networks. Before reconnecting the device to a network inanother country, contact your Xerox representative for assistance.Notes:• Although this product can use either loop disconnect (pulse) or DTMF tone signaling, Xeroxrecommends that you use DTMF signaling. DTMF signaling provides reliable and faster call setup.• Modification of this product, or connection to external control software or control apparatus notauthorized by Xerox, invalidates its certification.New Zealand1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom hasaccepted that the item complies with minimum conditions for connection to its network. It indicatesno endorsement of the product by Telecom, it does not provide any sort of warranty, and it does notimply that any Telepermitted product is compatible with all Telecom network services. Above all, itprovides no assurance that any item will work correctly in all respects with another item ofTelepermitted equipment of a different make or model.The equipment may not be capable of correct operation at the higher data speeds designated.33.6 kbps and 56 kbps connections are likely to be restricted to lower bit rates when connected tosome PSTN implementations. Telecom will accept no responsibility for difficulties that arise in suchcircumstances.2. Immediately disconnect this equipment should it become physically damaged, then arrange for itsdisposal or repair.3. This modem shall not be used in any manner which could constitute a nuisance to other Telecomcustomers.4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There isno guarantee that Telecom lines will always continue to support pulse dialing.5. Use of pulse dialing, when this equipment is connected to the same line as other equipment, maygive rise to 'bell tinkle' or noise and cause a false answer condition. If you encounter such problems,do not contact the Telecom Faults Service.306 Xerox ® WorkCentre® 7970 Multifunction PrinterUser Guide
