YASKAWA CIMR-E7 series Technical Manual

Installation 1-3Installation Check SheetThe following is a quick reference guide to install and configure the LONW ORKS Option. Make a copy of this page and check-off each item as itis completed. For detailed information please refer to the sections that follow.1: Unpack the LONW ORKS Option and verify that all components are present and undamaged. Refer to Figure 1.1 – L ONWORKSOption and Table 1.1 – Product Parts List.2: Connect power to the drive and verify that the drive functions correctly. This includes running the drive from the operatorkeypad. Refer to the appropriate drive user and/or technical manual for information on connecting and operating the drive.3: Remove power from the drive and wait for the charge lamp to be completely extinguished. Wait at least five additional minutesfor the drive to be completely discharged. Measure the DC bus voltage level to confirm that it is at a safe level.4: Install the LONW ORKS Option on the drive.4.1: Remove the operator keypad and all drive covers.4.2: Mount the LONW ORKS Option on the drive. Refer to Figure 1.2 – Mount the LONWORKS Option.4.3: Install the communications cable. Refer to Figure 1.3 – L ONWORKS Option E7, P7 and F7 Drive Connections, Figure 1.4– L ONWORKS Option E7L and E7B Connections and Figure 1.5 – L ONWORKS Option G7 Drive Connections.4.4: Connect a ground wire from the ground terminal on the LONW ORKS Option to a noise free ground. If a noise freeground point cannot be found, leave the ground terminal un-terminated.4.5: Set the termination resistor switch to the ON position on the driveís terminal assembly.5: Connect the LONW ORKS Option to the LONWORKS communication network. Refer to Figure 1.6 – L ONWORKS OptionConnections.7: Configure the LONWORKS network for the drive. The External Interface File (E7_LW.XIF) and the Device Resource Files(E7_LW.TYP, E7_LW.ENU, E7_LW.FPT, and E7_LW.FMT) may be found on the CD supplied with the drive or downloadedfrom www.drives.com.8: Apply power to the drive. Set parameters b1-0, b1-02, H5-01, H5-02, H5-03 and H5-07 to their appropriate values. Refer toTable 1.2 – Drive Parameter Settings.9: Cycle power to the drive. After power has been removed, wait until the charge lamp has been extinguished before reapplyingpower.10: Verify that the diagnostic LEDs on the front of the LONW ORKS Option are in their correct state. Refer to Table 1.3 –DiagnosticLED Status.11: Remove power from the drive and wait for the charge lamp to be completely extinguished. Wait at least five additional minutesfor the drive to be completely discharged. Measure the DC bus voltage level to confirm that it is at a safe level.12: Reinstall the operator keypad and all drive covers.