Yaesu VX-120 Operating Manual

Also see for VX-120 Series: Brochure Specifications Technical supplement

VX-120 OPERATING MANUAL10BELT CLIP INSTALLATION Connect the hanger to the rear of the VX-120, with the notch pointing directly up,using the supplied screw (Figure 1). Use only the screw included with the clip tomount the clip to the back of the VX-120. Clip the Quick-Draw Belt Clip onto your belt (Figure 2). To install the VX-120 into the Quick-Draw Belt Clip, align the hanger with the Quick-Draw Belt Clip, and slide the VX-120 into its slot until a click is heard (Figure 3). To remove the VX-120 from the Quick-Draw Belt Clip, rotate the VX-120 180 de-grees, then slide the VX-120 out from the Quick-Draw Belt Clip (Figure 4).INSTALLATION OF ACCESSORIESINSTALLATION OF FBA-25A ALKALINE BATTERY CASE (OPTION)The optional FBA-25A Battery Case allows operation of the VX-120 using six “AA” sizeAlkaline batteries.When installing batteries, insert the (–) end first, then press in the (+) end so the batterysnaps into place. Always replace all six batteries at the same time, paying attention to thepolarity indicated inside the case.The FBA-25A must not be used with rechargeable cells. The FBA-25A does not containthe thermal and over-current protection circuits (provided in the “FNB” series of Ni-MHBattery Packs) required when utilizing Ni-Cd and Ni-MH cells.Note that the power output and battery life will be much shorter when using Alkaline AAcells. They should be considered an emergency backup power source only, for this reason.Figure 4Figure 3Figure 2