Yaesu VX-120 Operating Manual

Also see for VX-120 Series: Brochure Specifications Technical supplement

VX-120 OPERATING MANUAL68The VX-120 Set Mode, already described in parts of many previous chapters, is easy toactivate and set. It may be used for configuration of a wide variety of transceiver param-eters, some of which have not been detailed previously. Use the following procedure toactivate the Set Mode:1. Press the [F] key, then press the [LOW(LOCK)SET] key toenter the Set mode.2. Rotate the DIAL knob to select the Set Mode Item to be ad-justed.3. Press the [F] key momentarily to enable adjustment of the SetMode Item.4. Rotate the DIAL knob to adjust or select the parameter to bechanged on the Set Mode Item selected in above step.5. After completing your selection and adjustment, press the PTT switch momentarily tosave the new setting and exit to normal operation.Some Set Mode Items (like Set Mode Item 46: TN FRQ) require that the [F]key be pressed after setting of the parameter, and before exiting to normaloperation.SET (MENU) MODESET MODE ITEM1 [APO]2 [ARTS]3 [AR INT]4 [ARS]5 [BCLO]6 [BEEP]7 [BELL]8 [BSY.LED]9 [CLK.SFT]10 [CWID]11 [CW WRT]12 [DC VLT]13 [DCS.COD]14 [DCS.N/R]15 [DT DLY]16 [DT SPD]17 [DT WRT]18 [ECS.CDR]19 [ECS.CDT]20 [EDG.BEP]FUNCTIONSetting of the Automatic Power-Off feature.Selects the Beep option during ARTS operation.Selects the Polling Interval during ARTS operation.Enables/Disables the Automatic Repeater Shift function.Enables/Disables the Busy Channel Lock-Out feature.Enables/Disables the beeper.Selects the number of CTCSS/DCS Bell ringer repetitions.Enables/Disables the BUSY LED while the Squelch is open.Shifting of the CPU clock frequency.Enables/disables the CW identifier during ARTS operation.Programs and activates the CW Identifier.Indicates the DC Supply Voltage.Setting of the DCS code.Enables/Disables “Inverted” DCS code decoding.Setting of the DTMF Autodialer Delay Time.Setting of the DTMF Autodialer Sending Speed.Programming of the DTMF Autodialer.Setting the Receiver Pager Code for the Enhanced CTCSSPaging & Code Squelch.Setting the Transmitting Pager Code for the EnhancedCTCSS Paging & Code Squelch.Enables/Disables the Band-edge beeper while selecting thefrequency via the DIAL knob.AVAILABLE VALUES(DEFAULT: BOLD ITALIC)OFF / 0.5H - 12.0 HINRANG / ALWAYS / OFF25 SEC / 15 SECARS. ON / ARS.OFFBCL. ON / BCL.OFFKEY+SC / KEY / OFFOFF / 1T / 3T /5T / 8T / CONTLED. ON / LED.OFFSFT.OFF / SFT. ONTX OFF / TX ON------104 DCS codes (023)T/RX N, RX R,TX R, T/RX R50MS / 100MS / 250MS /450MS / 750MS / 1000MS50MS / 100MS---(R05 47)(T05 47)BEP.OFF / BEP. ON