Yamaha 2007 FZ6-NA Service Manual

Contents

ENGINE3-811. Install:• Fuel tankRefer to "FUEL TANK" on page 7-1.• SeatRefer to "GENERAL CHASSIS" on page 4-1.EAS4S81012ADJUSTING THE EXHAUST GAS VOLUME(FZ6-N/FZ6-NA/FZ6-S/FZ6-SA)NOTE:Be sure to set the CO density level to stan-dard, and then adjust the exhaust gas volume.1. Turn the main switch to “OFF” and set theengine stop switch to “ON”.2. Simultaneously press and hold the“SELECT” and “RESET” buttons, turn themain switch to “ON”, and continue to pressthe buttons for 8 seconds or more.NOTE:“dIAG” appear on the odometer LCD.3. Press the “SELECT” button to select theCO adjustment mode “Co” “1” or the diag-nostic mode “dI”.4. After selecting “Co”, simultaneously pressthe “SELECT” and “RESET” buttons for 2seconds or more to execute the selection.NOTE:The selected cylinder number appears on theclock LCD.• To decrease the selected cylinder number,press the “RESET” button.• To increase the selected cylinder number,press the “SELECT” button.5. After selecting the cylinder, simultaneouslypress the “SELECT” and “RESET” buttonsfor 2 seconds or more to execute the selec-tion.6. Change the CO adjustment volume bypressing the “SELECT” and “RESET” but-tons.NOTE:The CO adjustment volume appears on thetripmeter LCD.• To decrease the CO adjustment volume,press the “RESET” button.• To increase the CO adjustment volume,press the “SELECT” button.7. Release the switch to execute the selec-tion.8. Simultaneously press the “SELECT” and“RESET” buttons to return to the cylinderselection (step 5).9. Turn the main switch to “OFF” to cancel themode.EAS4S81002ADJUSTING THE EXHAUST GAS VOLUME(FZ6-NHG(W)/FZ6-NAHG/FZ6-SHG(W)/FZ6-SAHG)NOTE:Be sure to set the CO density level to stan-dard, and then adjust the exhaust gas volume.1. Turn the main switch to “OFF” and set theengine stop switch to “ON”.Throttle cable free play3.0–5.0 mm (0.12–0.20 in)