Basic components19NOTE:After the main switch is first turned on, all seg-ments of the display come on as a test. Aftera few seconds, the gauge will change to nor-mal operation. Watch the gauge when turningon the main switch to make sure all segmentscome on.NOTE:The speedometer displays km/h, mph, orknots, according to operator preference. Se-lect the desired unit of measurement by set-ting the selector switch on the back of thegauge. See the illustration for settings.EMU26620Trim meter (digital type)This meter shows the trim angle of your out-board motor.NOTE: Memorize the trim angles that work best foryour boat under different conditions. Adjustthe trim angle to the desired using the pow-er trim and tilt switch. If the trim angle of your motor exceeds thetrim operating range, the top segment onthe trim meter display will blink.EMU26650Hour meter (digital type)This meter shows the number of hours the en-gine has been run. It can be set to show thetotal number of hours or the number of hoursfor the current trip. The display can also beturned on and off.1. Speedometer2. Fuel gauge3. Trip meter/clock/voltmeter4. Warning indicator(s)1. Cap2. Selector switch (for speed unit)3. Selector switch (for fuel sensor)ZMU01740ZMU01741
