Trouble Recovery65EMU29471Replacing fuseIf a fuse has blown, remove the electrical cov-er, open the fuse holder and remove the fusewith a fuse puller (if equipped). Replace it witha spare one of the proper amperage.WARNINGEWM00630Be sure to use the specified fuse. An in-correct fuse or a piece of wire could allowexcessive current flow. This could causeelectric system damage and a fire hazard.NOTE:Consult your Yamaha dealer if the new fuseimmediately blows again.EMU29520Power trim and tilt will not operateIf the engine cannot be tilted up or down withthe power trim and tilt/ the power tilt becauseof a discharged battery or a failure with thepower trim and tilt unit/the power tilt, the en-gine can be tilted manually.1. Loosen the manual valve screw by turn-ing it counterclockwise until it stops.1. Electrical cover2. Fuse puller3. Accessory fuse (50 A)4. Main fuse (50 A)5. Main switch / trim switch fuse (20 A)6. Engine control unit / ignition coil / electricfuel pump / fuel injector / ISC (idle speedcontrol) fuse (20 A)7. Starter relay fuse (30 A)8. Spare fuse (20 A, 30 A, 50 A)
