POWR Power unit5-27 69J1D11Installing the sprockets and timingbelt1. Install the driven sprockets 1, and thentighten the bolts to the specified torque.2. Check that “I” marks a and b on thedriven sprockets are aligned with marksc and d. Align if necessary.3. Install the new gaskets, cylinder headcover 2, and then tighten the bolts to thespecified torques in two stages.4. Install the drive sprocket 3 and timingbelt tensioner 4, and then tighten thebolts to the specified torques.5. Check that the “ ” mark e on the plateis aligned with the “ ” mark f on thecylinder block. Align if necessary.6. Using a hexagon wrench, turn the timingbelt tensioner 4 clockwise to push thetiming belt, increase strength gradually,and then insert a ø5.0 mm (0.2 in) pin 5into the hole g.T R..Driven sprocket bolt:60 N·m (6.0 kgf·m, 43 ft·lb)Cylinder head cover bolt:1st: 8 N·m (0.8 kgf·m, 5.8 ft·lb)2nd: 8 N·m (0.8 kgf·m, 5.8 ft·lb)T R..Drive sprocket bolt:7 N·m (0.7 kgf·m, 5.1 ft·lb)Timing belt tensioner bolt:39 N·m (3.9 kgf·m, 28 ft·lb)
