69J1D11 3-81234567895. Install the oil filter, and then tighten it tothe specified torque using a 72.5 mm(2.9 in) oil filter wrench.6. Pour the specified amount of the recom-mended engine oil into the oil filler hole.7. Install the oil filler cap and dipstick, andthen start the engine and warm it up for 5minutes.8. Turn the engine off, and then check theoil level and correct it if necessary.9. Install the oil filter cover.Checking the timing belt1. Remove the flywheel magnet cover.2. While turning the flywheel magnet clock-wise, check the interior a and the exte-rior b of the timing belt for cracks,damage, or wear. Replace if necessary.3. Turn the crankshaft clockwise two turnsto take up slack in the timing belt.Replacing the timing beltNOTE:For replacement procedures, see Chapter 5,“Replacing the timing belt.”Checking the valve clearanceNOTE:For checking procedures, see Chapter 5,“Checking the valve clearance.”Checking the spark plugs1. Remove the ignition coil cover.2. Disconnect the spark plug wires, andthen remove the spark plugs.3. Clean the electrodes 1 with a spark plugcleaner or wire brush. Replace the sparkplug if necessary.4. Check the electrodes for erosion andexcessive carbon or other deposits, andthe gasket for damage. Replace thespark plug if necessary.T R..Oil filter: 18 N·m (1.8 kgf·m, 13 ft·lb)Recommended engine oil:4-stroke motor oilAPI: SE, SF, SG, SH, or SJSAE: 10W-30 or 10W-40Oil quantity:With oil filter replacement:6.0 L (6.3 US qt, 5.3 Imp qt)Power unit
