Maintenance868. Remove the oil filler cap.9. Prepare a suitable container that holds alarger amount than the engine oil capac-ity. Remove the drain screw and gasketwhile holding the container under thedrain hole. Let the oil drain completely.Wipe up any spilled oil immediately.TIP:If the oil does not drain easily, change the tiltangle or turn the outboard motor to port andstarboard to drain the oil.10. Put a new gasket on the drain screw.Apply a light coat of oil to the gasket andinstall the drain screw.TIP:If a torque wrench is not available when youare installing the drain screw, finger tightenthe screw just until the gasket comes intocontact with the surface of the drain hole.Then tighten 1/4 to 1/2 turn more. Tightenthe drain screw to the correct torque with atorque wrench as soon as possible.11. Add the correct amount of oil through thefiller hole. NOTICE: Overfilling the oilcould cause leakage or damage. If theoil level is above the upper level1. Apron1. Oil filler cap1ZMU079581ZMU069511. Drain screw2. GasketDrain screw tightening torque:27 Nm (2.75 kgf-m, 19.9 ft-lb)12ZMU07959©2017 Yamaha Motor Corporation, U.S.A.
