4-58HANDLEBAR CHAS26 Nm (2.6 mkg, 19 ftlb)NOTE:NOTE:26 Nm (2.6 mkg, 19 ftlb)WARNING5. Install: grip end6. Adjust: throttle cable free playRefer to “ADJUSTING THE THROTTLECABLE FREE PLAY” in chapter 3.Throttle cable free play (at theflange of the throttle grip)3  5 mm (0.12  0.20 in)7. Install: clutch lever holder 1 clutch cableAlign the slit on the clutch lever holder with thepunch mark a on the handlebar.8. Adjust: clutch cable free playRefer to “ADJUST THE CLUTCH CABLEFREE PLAY” in chapter 3.Clutch cable free play (at the endof the clutch lever)10  15 mm (0.39  0.59 in)9. Install: left handlebar switchAlign the projection a on the left handlebarswitch with the hole b on the handlebar.10. Install: handlebar grip grip enda. Apply a thin coat of rubber adhesive onto theleft end of the handlebar.b. Slide the handlebar grip over the left end ofthe handlebar.c. Wipe off any excess rubber adhesive with aclean rag.Do not touch the handlebar grip until therubber adhesive has fully dried.

important manual information

how to use this manual

MOTORCYCLE IDENTIFICATION

FEATURES

FI SYSTEM

INSTRUMENT FUNCTION

IMPORTANT INFORMATION

LOCK WASHERS /PLATES AND COTTER PINS

CHECKING THE CONNECTIONS

SPECIAL TOOLS

SPECIFICATIONS SPEC

specifications

engine specifications

chassis specifications

tightening torques

lubrication points and lubricant types

cable routing

periodic checks and adjustments

fuel tank

air filter case

electrical system

CHASSIS CHAS

rear shock absorber assembly

swingarm and drive chain

valves and valve springs

starter clutch and generator

shift shaft

connecting rods and pistons

oil cooler

water pump

throttle bodies

air induction system

checking switch continuity

checking the bulbs and bulb sockets

starter motor

charging system

lighting system

fuel pump system

troubleshooting

faulty gear shifting

poor braking performance

unstable handling

Yamaha FZ6-SS 2004 Service Manual

FZ6-S 2004

FZ6-SS 2004