4 - 13ENGCYLINDER HEADINSTALLING THE CYLINDER HEAD1.Install: Cylinder head Bolt (M10) Bolt (M6)NOTE: Lubricate the washer with engine oil. Tighten the bolts (M10) in two stages and acrisscross pattern.T R..40 Nm (4.0 m • kg, 29 ft • lb)T R..10 Nm (1.0 m • kg, 7.2 ft • lb)2.Install: Camshaft sprocket*****************************************************Installing steps: Rotate the camshaft to align the camshaftpin 1 with the cylinder head match mark 2. Turn the crankshaft counterclockwise with awrench. Align the “T” mark 3 on the rotor with thestationary pointer 4 on the crankcase cover.When the “T” mark is aligned with thestationary pointer, the piston is at the TopDead Center (T.D.C.).CAUTION:Do not turn the crankshaft during thecamshaft sprocket installation. Place the timing chain onto the camshaftsprocket. Install the camshaft sprocket onto thecamshaft and finger tighten the sprocket bolt.
