4 - 86ENGMIDDLE GEAR Tighten the bearing retainer.CAUTION:The middle driven shaft bearing retainerhas left-handed threads. To tighten theretainer turn it counterclockwise.*****************************************************3.Install: Shims 1 Bearing housingNOTE:Install the shims so that the tabs are positionedas shown in the illustration.T R..Bearing retainer:110 Nm (11.0 m • kg, 80 ft • lb)4.Install: Universal joint yoke (rear side) Washer Nut 1NOTE:Use the universal joint holder 2 to hold theyoke.Universal joint holder:P/N. YM-04062, 90890-04062LTT R..97 Nm (9.7 m • kg, 70 ft • lb)5.Install: Universal joint*****************************************************Installation steps: Install the opposite yoke into the U-joint. Apply wheel bearing grease to the bearings.
