Yamaha YFM660RN Service Manual

Contents

3 - 15CHKADJADJUSTING THE STARTER CABLEADJUSTING THE STARTER CABLE1.Adjust: Starter cable***********************************************Adjustment steps: Disconnect the starter cable 1 from the car-buretor body.NOTE:Do not remove the starter plunger 2 from thestarter cable. Measure the starter plunger stroke distancea of the starter lever 3 fully close-to-fullyopen position.If the distance is out of specification adjust itas described below.È Fully closed positionÉ Fully open position Pull back the boot 4. Loosen the locknut 5. Turn the adjuster 6 in or out until the correctdistance is obtained. Tighten the locknut 5. Push in the boot 4. Connect the starter cable.WARNINGAfter adjusting the cable, turn the handle-bar to right to left, and make sure that theengine idling speed does not increase.***********************************************Starter plunger stroke distance a:15 mm (0.59 in)Turning in Distance increased.Turning out Distance decreased.