HANDLEBAR4-34in place on both sides.• Install the handlebar so that the projection “c”of the upper handlebar holders is positioned atthe mark on the handlebar as shown.• First tighten the bolts on the front side of theupper handlebar holder, and then tighten thebolts on the rear side.4. Tighten:• Lower handlebar holder nut “1”5. Install:• Left grip “1”Apply the adhesive to the handlebar “2”.TIP• Before applying the adhesive, wipe off greaseor oil on the handlebar surface “a” with a lac-quer thinner.• Install the left grip to the handlebar so that theline “b” between the two arrow marks facesstraight upward.6. Install:• Engine stop switch “1”• Clutch lever holder “2”• Clutch lever holder bolt “3”• Clamp “4”TIP• The engine stop switch, clutch lever holder andclamp should be installed according to the di-mensions shown.• Pass the engine stop switch lead in the middleof the clutch lever holder.Lower handlebar holder nut40 N·m (4.0 kgf·m, 30 lb·ft)T R. .Engine stop switch screw0.5 N·m (0.05 kgf·m, 0.37 lb·ft)Clutch lever holder bolt5 N·m (0.5 kgf·m, 3.7 lb·ft)Clutch lever nut4.0 N·m (0.40 kgf·m, 3.0 lb·ft)T R. .T R..