CRANKSHAFT5-41EAM30491REMOVING THE CRANKSHAFT1. Remove:• Crankshaft “1”(with the crankcase separating tool “2”)TIPMake appropriate bolts “3” as shown availableby yourself and attach the tool with them.NOTICEECA22290Do not use a hammer to drive out the crank-shaft.EAM30492CHECKING THE CRANKSHAFT1. Measure:• Crankshaft runout “a”Out of specification Replace the crank-shaft.TIPTurn the crankshaft slowly.2. Measure:• Crank assembly width “a”Out of specification Replace the crank-shaft.EAM30493INSTALLING THE CRANKSHAFT1. Install:• Crankshaft assemblyTIPInstall the crankshaft assembly with the crank-shaft installer pot “1”, crankshaft installer bolt “2”,and adapter (M12) “3”.TIPHold the connecting rod at top dead center(TDC) with one hand while turning the nut of thecrankshaft installer bolt with the other. Turn thecrankshaft installer bolt until the crankshaft as-sembly bottoms against the bearing.Crankcase separating tool90890-01135Crankcase separatorYU-01135-BRunout limit0.050 mm (0.0020 in)a aCrank assembly width59.95–60.00 mm (2.360–2.362 in)Crankshaft installer pot90890-01274Installing potYU-90058Crankshaft installer bolt90890-01275BoltYU-90060Adapter (M12)90890-01278Adapter #3YU-90063123