START-UPCarl Zeiss Reflector turret Axiovert 2002-16 B 40-080 e 03/01• To remove a reflector module no longer required, first pull it out of the upper spring clamps and thenfrom the lower ones.• When equipment has been finished, attach the plastic hood again and press it downwards until theholding catches on the right and left engage in the lower part of the reflector turret.2.7.3 Changing the filter set in the FLreflector moduleThe filter sets for the FL reflector module can becompiled and assembled by the customer himselfas required. Suitable filter sets or completelyassembled FL reflector modules can be orderedfrom Carl Zeiss.• Remove FL reflector module (2-18/3) from thereflector turret.• Use mounting device from the tool set tounscrew retainer ring (2-18/1).• Turn the reflector module around and allow thefilter (2-18/2 or 4) to drop on a soft surface.• The barrier filter is inserted at (2-18/2), theexcitation filter at (2-18/4), and both aresecured using the retainer rings (2-18/1).2.7.4 Changing the beam splitter in theFL reflector moduleAssembly of the filter and the beamsplitter requires utmost care toprevent damage and contaminationof the optical components.We would recommend you to order completelyequipped FL reflector modules, since changing thebeam splitter requires much skill.Otherwise, proceed as follows:• Remove FL reflector module from the reflectorturret.• Use screwdriver to loosen two slotted screws(2-19/1).Fig. 2-18 Changing the filter set in the FLreflector moduleFig. 2-19 Changing the beam splitter
