START-UPAxiovert 200 Interfaces ... / Microscope and power supply ... Carl ZeissB 40-080 e 03/01 2-192.9 Interfaces of the Axiovert 200 MPrior to connecting any components,switch off the microscope.The Axiovert 200 M is connected to a PC via theRS 232 interface (2-23/2).Motorized components of the Axiovert 200 M(e.g. the motorized condenser) are connected viathe SB interfaces (2-23/3).Further external control components (e.g. the 3-axis motor control MCU 28 of the scanning stage)must be connected to the CAN/SB connectors(2-23/1).2.10 Switch microscope and ebq 100 dcpower supply on and off• Switch the microscope on and off using the lineswitch (2-24/1).• If a fluorescence illuminator (e.g. N HBO 103) isconnected (see section 2.13.3, "Attachment ofilluminator N HBO 103"), switch power supplyebq 100 dc on and off via the line switch(2-24/2).2.11 Equipotential bonding terminalsTerminals for equipotential bonding forelectrophysiological measurements are located onthe rear side of the stand (2-23/4) and on theunderside of the binocular tubes (000000-1005-827 and 000000-1005-828).Connection to the stand is by 4mm banana plugs.The connectors on the tubes are provided with M4internal thread.Fig. 2-23 Axiovert 200 M (rear)Fig. 2-24 Power supply ebq 100 dc (front)
