Installing the Switch 1000 2-5Wall MountingA single Switch can be wall-mounted.CAUTION: Disconnect any cables from the unitbefore continuing. Remove self-adhesive pads fromthe underside of the unit if they have been previ-ously fitted.1 Place the Switch the right way up on a hard flat sur-face, with the front facing towards you.2 Locate a mounting bracket over the mountingholes on one side of the unit, as shown inFigure 2-3.3 Insert the two screws and tighten with a suitablescrewdriver.4 Repeat for the other side of the unit.5 Ensure that the wall you are going to use is smooth,flat, dry and sturdy. Attach a piece of plywood,approximately 305mm x 510mm x 12mm (12in. x20in. x 0.5in.) securely to the wall if necessary, andmount the Switch as follows:a Position the base of the unit against the wall (orplywood) ensuring that the ventilation holes facesidewards. Mark on the wall the position of thescrew holes in both wall brackets. Drill the fourholes.b Using suitable fixings and screws (not provided),attach the Switch unit securely to the wall or ply-wood.c Connect network cabling.Figure 2-3 Fitting a bracket for wall mounting
