3-12 CHAPTER 3: ACCESSING THE SWITCHDisplaying SNMPSettingsTo display the SNMP settings configured on the Switch 3800, use thefollowing command:show managementThis command displays the following information:n Enable/disable state for telnet, SNMP, and web accessn SNMP community stringsn Authorized SNMP station listn SNMP trap receiver listn Logon statisticsResetting andDisabling SNMPTo reset or disable SNMP settings, use the commands in Table 3-5.Checking BasicConnectivityThe Switch 3800 has the following two facilities for checking basicconnectivity:n pingn traceroutePing The ping command allows you to send Internet Control MessageProtocol (ICMP) echo messages to a remote IP device. The pingcommand is available for both the user and administrator privilegelevel.The ping command syntax is as follows:ping {continuous} {size } Table 3-5 SNMP Reset and Disable CommandsCommand Descriptiondisable snmp access Allows you to disable SNMP on the Switch.disable snmp trap Allows you to prevent SNMP traps from being sent fromthe Switch.unconfig management Restores default values to all SNMP-related entries.
