|
Switch 3800 Commands 4-23Configuration andImage CommandsTable 4-19 describes configuration and image commands.config syslog {} {}Allows you to configure the syslog host address andfilter messages sent to the syslog host. Options include:n ipaddress — The IP address of the syslog host.n facility — The syslog facility level for local use.n priority — Filters the log to display message with theselected priority or higher (more critical). Prioritiesinclude critical, warning, and informational. If notspecified, only critical priority messages are sent tothe syslog host.n subsystem — Filters the log to display messagesassociated with the selected Switch subsystem.Subsystems include Syst, STP Brdg, SNMP, Telnet,VLAN, and Port. If not specified, all subsystems aresent to the syslog host.enable log display Allows you to enable the log display.enable syslog Allows you to enable logging to a remote syslog host.disable log display Allows you to disable the log display.disable syslog Allows you to disable logging to a remote syslog host.Table 4-18 Logging Commands (continued)Command DescriptionTable 4-19 Configuration and Image CommandsCommand Descriptionsave {config} {primary | secondary} Allows you to save the current configuration of theSwitch to NVRAM. You can specify the primary orsecondary configuration area. If not specified, theconfiguration is saved to the configuration areacurrently in use.use config {primary | secondary} Allows you to configure the Switch to use a particularconfiguration on the next reboot. Options include theprimary configuration area, the secondaryconfiguration area, or an imported ASCII file. If notspecified, the Switch will use the primary configurationarea.use image {primary | secondary} Allows you to configure the Switch to use a particularimage on the next reboot. If not specified, the Switchwill use the primary image.(continued)
|
