4-20 CHAPTER 4: COMMANDSRIP Commands Table 4-17 describes the commands used to configure the RIP protocol.Table 4-17 RIP CommandsCommand Descriptionshow rip {vlan | all} Displays RIP configuration and statistics for one or moreVLANs. Display includes the state for RIP settings, andinterface states. Statistics include the following:n Packets transmittedn Packets receivedn Bad packets receivedn Bad routes receivedn Number of RIP peersn Peer informationenable rip Allows you to enable RIP.disable rip Allows you to disable RIP.config rip add {vlan | all} Allows you to configure RIP on an IP interface. If noVLAN is specified, then “all” is assumed. When an IPinterface is created, per interface RIP configuration isenabled by default.config rip delete {vlan | all} Allows you to disable RIP on an IP interface. When RIPis disabled on the interface, the parameters are notreset to their defaults.enable rip aggregation Allows you to enable RIP aggregation of subnetinformation on a RIP version 2 interface. The defaultsetting is enabled.disable rip aggregation Allows you to disable the RIP aggregation of subnetinformation on a RIP version 2 interface.enable rip splithorizon Allows you to enable the split horizon algorithm forRIP. Default setting is enabled.disable rip splithorizon Allows you to disable split horizon.enable rip poisonreverse Allows you to enable the split horizon withpoison-reverse algorithm for RIP. The default setting isenabled.disable rip poisonreverse Allows you to disable poison reverse.enable rip triggerupdate Allows you to enable triggered updates. Triggeredupdates are a mechanism for immediately notifying arouter’s neighbors when the router adds or deletesroutes, or changes the metric of a route. The defaultsetting is enabled.disable rip triggerupdate Allows you to disable triggered updates.(continued)
